Vitek VT-8435, Инструкция по эксплуатации

Страница: 3 / 28

3
ENGLISH
MULTISTYLER VT-8435
The multistyler is used for hair straighten-
ing, for making 3D curls and for making
crinkles or deep waves on your hair.
DESCRIPTION
1. Heating plates locks
2. Operating surfaces
3. Hair clamp handle
4. Pilot light
5. Power switch «O/I»
6. Heating plate lock
7. Hanging loop
ATTENTION!
–
Do not use the unit near water in bath-
rooms, shower rooms, swimming pools
etc.
–
After using the unit in a bathroom,
unplug it by taking the power plug
out of the mains socket, as closeness
of water is dangerous even if the unit is
switched off.
–
For additional protection it is advised to
install a residual current device (RCD)
with nominal operation current not
exceeding 30 mA into the bathroom
mains; contact a specialist to have
it installed.
–
Place the unit on a flat steady heat-
resistant surface. Make sure that the
heating plates and outer operating sur-
faces do not touch fusible and inflam-
mable objects (of plastic, polyethylene
and synthetic materials etc.).
SAFETY PRECAUTIONS
Before using the electrical unit, thoroughly
read through this instruction manual and
keep it for future reference.
Use the unit for its intended purpose only,
as specified in this manual. Mishandling
of the unit may lead to its breakage and
cause harm to the user or damage to his/
her property.
•
Before switching the unit on, make sure
that voltage of the mains corresponds
to unit operating voltage.
•
Do not use the unit to curl wet hair or
synthetic wigs.
•
Hair spray should be applied only after
hair curling is finished.
•
Do not switch the unit on in places
where aerosols are sprayed or highly
flammable liquids are used.
•
Do not put the operating unit on heat-
sensitive or soft surfaces (for instance,
bed or couch) and do not cover the unit.
•
It is recommended to unwind the power
cord to its full length while using the unit.
•
The power cord should not:
–
touch hot objects;
–
extend over sharp furniture edges;
–
be used as a handle for carrying
the unit.
•
Never leave the operating unit unat-
tended.
•
Always unplug the unit immediately
after usage and before cleaning.
•
When unplugging the unit, pull the
power plug but not the power cord.
•
Do not touch the unit body, power cord
and power plug with wet hands.
•
Do not use the unit while taking a bath.
•
Do not hang or keep the unit in places
where it can fall into a bath or a sink
filled with water; do not immerse the
unit body, power cord or power plug
into water or other liquids.
•
If the unit is dropped into water, unplug
it immediately and only then take it out
of water.
•
Do not use the unit when you are
drowsy.
•
During the operation, hold the unit by
its handle only, do not touch the oper-
ating surface.
•
Avoid contact of heated surfaces with
your face, neck and other parts of your
body.
Be careful! The operating surface
remains hot for some time after the unit
is unplugged.
•
For children’s safety reasons do not
leave polyethylene bags used as pack-
aging unattended.
VT-8435_105 x148.indd 3 3/23/20 3:45 PM