Vitek VT-8246, Инструкция по эксплуатации

Страница: 6 / 44

6
ENGLISH
If the attachment is set properly, you’ll hear the lock (3)
clicking.
•
Before switching the unit on, make sure that your
home mains voltage corresponds to the unit operat-
ing voltage.
USING THE HOT AIR STYLER
•
Make sure that the operation mode switch (4) is set to
the position «
0 ».
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the
switch (4):
«
0 » – the hot air styler is off;
« » – «cool» air supply;
« 1 » – low air flow temperature;
« 2 » – high air flow temperature;
•
If necessary, adjust the diameter of the thermo-brush
as shown in the figure (fig. 1).
Note: During the first operation some foreign smell and
a small amount of smoke from the heating element are
possible, this is normal.
•
After the hot air styler operation is finished, switch it
off by setting the switch (4) to the «
0 » position and
unplug it.
•
Wait till the hot air styler cools down.
•
Remove the attachment; to do this, press on the lock
(3) and remove the attachment.
•
Periodically straighten the cord if it gets twisted dur-
ing operation.
Overheating protection
Overheating protection switches the hot air styler off if
the temperature of the outgoing air is above the limit.
If the hot air styler is switched off during operation, set
the switch (4) to the «
0 » position, unplug the unit and
make sure that the inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes and switch it on
again. Do not block the air inlets during the hot air styler
operation and avoid getting of hair into the air inlets (6).