Vitek VT-6604 BK, Инструкция по эксплуатации

Страница: 7 / 48

7
ENGLISH
digits and the selected alarm indicator (11) or (13) will
appear on the display.
•
Consequently press or hold the button (2) « HOUR/
9
»
to set the alarm time in hours.
•
Consequently press or hold the button (3) « MIN/
:
»
to set the alarm time in minutes.
•
To finish the setup procedure press the button (4)
« ALM1 » or the button (5) « ALM2 » respectively.
•
Select the necessary alarm signal: sound signal
(« Buzzer » symbol) or radio switch on (« Radio » symbol).
To do it, consequently press the button (4) « ALM1 » or
the button (5) « ALM2 » in the current time mode.
Depending on your choice the corresponding indicator
will light up:
– the indicator (11) shows that the first alarm sound signal
is selected as an alarm signal;
– the indicator (12) shows that the radio is selected as the
first alarm signal;
– the indicator (13) shows that the second alarm sound
signal is selected as an alarm signal;
– the indicator (14) shows that the radio is selected as the
second alarm signal;
Notes:
– If you want to select the radio as an alarm signal,
tune in to a required radio station preliminarily (see
“Radio stations reception”).
– The alarm actuation is possible only when the unit is
connected to the mains.
– If the buttons (2) «HOUR/
9
» or (3) «MIN/
:
» are
not pressed within 10 seconds during the setup
process, the unit will be switched back to the cur-
rent time mode .
– At the alarm actuation the volume level increases
gradually from minimal to maximal value within
10 seconds.
Switching the alarms on/off
•
To switch the alarm (alarms) off in the current time mode
consequently press the button (4) « ALM1 » or the but-
ton (5) « ALM2 », until the corresponding alarm indica-
tors go out.
•
To switch the alarm (alarms) on in the current time mode
consequently press the button (4) « ALM1 » or the but-
ton (5) « ALM2 », until the corresponding alarm indica-
tor lights up.
VT-6604_IM_70x130.indd 7 01.07.2015 17:24:17