ENGLISH
7
Operation from an external power source
To operate the weather station from an exter-
nal power source, a USB cable is included.
Connect the supplied USB cable to the exter-
nal power socket (27).
As a power source, you can use the USB
port of a computer, monitor, smart-
phone charger, Power Bank, or any power
source that has a USB output. The out-
put voltage of the power supply shall not
exceed 4.5-5 V.
Switching the display light on
– Press the «LIGHT/SNZ» (3) or (8) button
to turn the display lighting on. The light-
ing stays on for 5 seconds and will be
switched off automatically.
Note: - when operating from an exter-
nal power source, the display lighting is
always on.
Weather forecast
Icons showing the weather forecast vary
depending on changes in humidity and tem-
perature (certainly, they are less accurate
than forecasts prepared by professional
weather services and may only be used for
reference). Changes in temperature and
humidity are evaluated every 30 seconds.
The station shows the forecast for the next
12 hours in the form of icons:
Sunny
Cloudy
Оvercast
Rain
View maximum and minimum
temperature and humidity values
The unit memory stores the data on maxi-
mum and minimum temperature and relative
humidity values for the period of continu-
ous operation.
To view the maximum, minimum, and cur-
rent temperature and humidity values, press
the «MAX/MIN» button (7) sequentially.
Together with the digital indications for
indoor temperature (15), digital indications
for indoor relative humidity (23), and digi-
tal indications for outdoor temperature (24)
the corresponding «MAX» or «MIN» indica-
tions will appear on the display (2). To reset
the maximum or minimum values, press and
hold the «MAX/MIN» button (7) for more
than 2 seconds.
Temperature scale selection «°С or °F»
– To change the temperature units, press
the «DOWN» button (6). The temperature
units will be changed.
MAINTENANCE
•
Do not disassemble the unit by yourself,
there are no parts inside the weather sta-
tion body which require replacement.
•
Check the batteries in the external sensor
(10) and the main unit (1), if necessary,
replace them.
•
Use only new batteries, do not install new
and old batteries together.
•
Insert the batteries, strictly following the
polarity.
•
After changing the batteries set the cur-
rent time on the main unit (1) and recon-
nect it with the external sensor (10).
•
Clean the main unit (1) body and the exter-
nal sensor (10) with a soft, slightly damp
cloth, and then wipe them dry.
•
Do not use abrasives or solvents.
•
Do not immerse the main unit (1) and
the external sensor (10) into water or any
other liquids.
STORAGE
•
If you are not going to use the weather sta-
tion for a long time, it is recommended to
remove the batteries from the main unit (1)
and the external sensor (10).
•
Keep the unit in a dry cool place out of
reach of children and disabled persons.
DELIVERY SET
Weather station – 1 pc.
External wired sensor – 1 pc.
USB power cable –1 pcs.
Instruction manual – 1 pc.
