Vitek VT-6406, Инструкция по эксплуатации

Страница: 9 / 44

frame will switch on and off automatically
Brightness : Display brightness selection from 1 to 16
Contrast : Display contrast selection from 1 to 16
Saturation : Display saturation selection from 1 to 16
Time zone :
Local time setting, using time shift
Time /date : Date and time setting
Date format : Date format selection: day/month or month/day
Time format : Time format selection: 12 or 24 hours
Alarm : Setting alarm actuation time, switching on and off
Receipt from external sensor :
Automatically – default setting
Search – searching signals from remote sensor
Weather forecast : Weather conditions selection:
Pressure units : Pressure unit selection: hPa, mmHg, inHg & mb
External channel displaying :
Automatically – Data displaying from the found channels
Only 1 channel – Data displaying from the 1 channel
Only 2 channel – Data displaying from the 2 channel
Only 3 channel – Data displaying from the 3 channel
Settings reset: yes/no
Weaving version: W232-R 1.05.200
Notes:
•
When electric energy is switched off for 1 minute, synchronization of the base unit with
the remote sensor and weather forecast data are stored. In 1 minute the unit switches
off completely. Further you will have to synchronize operation of the base unit and the
remote sensor again, enter the data, which are necessary for weather forecast.
•
Each time after batteries changing in the remote sensor you will have to synchronize
operation of the base unit and the remote sensor again.
•
USB- jack should not be used as an energy source or charging device for a USB-device,
different from a USB flash drive, otherwise photo frame can be broken.
•
If the base unit does not receive signal from the remote sensor for a long time, check the
batteries in the remote sensor, replace them if necessary and repeat synchronization.
Place the remote sensor within the radius of effective data transfer, as close as possible
to the base unit. Locate the base unit and the remote sensor in places with minimal inter-
ferences for better data transfer.
Take into account that the radius of data transfer of the
remote sensor depends on the material of partitions of the room and their number. Try
several location variants of the remote sensor and the base unit. Place the remote sen-
sor in such a way, that direct sunlight, rain or snow does not get on it. Home devices
(doorbell, alarm system etc) can interfere when the base unit receives data signal from
the remote sensor. It is normal and does not influence general operation. Transfer and
receipt of data signal will resume after interferences are removed.
•
When the remote control operation is unstable reduce distance between the remote
control and the base unit. Check the battery in the remote control and replace it if nec-
essary.
ENGLISH
9
6406_IM.indd 9 6406_IM.indd 9 12.03.2010 10:19:42 12.03.2010 10:19:42