Vitek VT-5280 W, Инструкция по эксплуатации, Страница: 4 / 20

4
ENGLISH
Battery installation
•
Open the battery compartment lid (2).
•
Insert three “AAA” batteries (not supplied) into the battery
compartment, strictly following the polarity.
•
Close the battery compartment lid (2).
ATTENTION!
Battery leakage can lead to injuries or damages of the unit.
To avoid damaging the batteries follow the instructions
below:
–
Insert the batteries strictly following the polarity;
– Remove the batteries if you are not planning to use the unit
for a long time;
–
do not recharge or disassemble the batteries, do not
expose them to high temperature;
–
replace the batteries in time;
USAGE
When using UV lamp for drying the gel nail polish:
–
apply a base layer of nail polish to your nails and place your
fingers into the chamber (4) in the lamp body (1), the UV
LEDs (3) will be switched on; cure the base layer for 3 min-
utes. Remove your hand from the chamber, the lamp will be
automatically switched off;
–
apply the first layer of nail polish and cure for 3 minutes;
– apply the next layers of nail polish and cure each layer for
3 minutes.
Note:
– apply the nail polish in a thin even layer;
– cure each layer for no less than 3 minutes; the curing time
may vary depending on the type of nail polish, so select the
curing time experimentally;
– after curing some nail polishes can remain sticky; this is
important for better application of the next polish layer;
– it is recommended to find the best position of fingers
relative to the UV LEDs during the nail polish drying experi-
mentally;
•
Nail stickers are supplied with the unit; cover them with nail
polish/gel nail polish and dry under the lamp.
CLEANING AND CARE
•
Provide that no nail polish gets on the UV LEDs and on the
inner and outer surfaces of the unit body.
•
Do not use abrasives and solvents to clean the unit body.
•
Clean the unit body (1) with a slightly damp cloth and then
wipe it dry.
•
From time to time wipe the UV LEDs with a dry cloth.
•
Keep the unit away from children in a dry cool place.
IM VT-5280_70x130.indd 4 19.06.2017 12:30:45