Vitek VT 3534, Инструкция по эксплуатации

Страница: 8 / 22

ALARM SETTING
i. Select Alarm 1 ( 1) or Alarm 2 ( 2) by pressing MODE
ii. Press HOUR to set the hour and MINUTE to set the minute
iii. Press ALARM /( C/F ) to enable or disable
the alarm function
• The alarm clock is last for 2 minutes and will
be repeated 5 minutes later when
MODE/SNOOZE key is pressed.
SETUP
Automatic Learn Function:
1. Learn function executes automatically and runs for approximately 3 min-
utes when batteries are first installed in the receiver.
2. Within these 3 minutes, receiver picks up the temperature & humidity sig-
nals from remote transmitter and displays the readings.
Manual-Learn (Searching for Remote Signals):
If a new remote transmitter is added or if signal is lost (outdoor display blink-
ing), learn function must be executed again.
1. Press & hold
CHANNEL for 3 seconds to
start.
2. Beep sound indicates that learn function
has started.
3. Channel symbol will flash and unit will beep
as each remote sensor is detected.
4. Temperature readings of remote transmitter
displays on the receiver.
ENGLISH
6
3534.qxd 22.09.2004 15:22 Page 6