ENGLISH
7
the crown against the hair growth di-
rection.
•
You can cut hair against and along
the hair growth direction, but keep
in mind that haircut against the
growth direction will be shorter than
the haircut along it.
•
Use the 3 mm attachment comb (6)
and 6 mm attachment comb (7) for
very short haircut. To leave longer hair,
use the necessary 9 mm comb (8) or
12 mm attachment comb (9).
•
To leave longer hair, take hair locks
between your fingers and cut hair
using the clipper (pic. 5).
•
You can use the comb (11): lift the
hair locks and cut them above the
comb (pic. 6).
•
Always start cutting from the head
back.
•
Set the hair with the comb (11) to
reveal uneven locks.
•
Use the scissors (12) to make hair-
cut even
Step 5 – the final part
–
In the final stage of haircut remove
the attachment comb from the unit,
turn the the blades of clipper towards
the hair and carefully trim hair on the
temples and neck. Do not press the
clipper strongly, there is danger of
injuries or cuts when open blades
come in contact with skin (fig. 7).
–
After finishing of hair cutting put the
protective cover (10) on the blades
(3, 4).
Cone-shaped haircut
Set the necessary attachment comb
and start cutting from the head back
towards the crown. Cut hair against hair
growth from the head front to the crown
and on the head sides (Pic. 8). To get a
flat top haircut, use the comb (11): lift
the locks and cut them along the comb.
Set the hair with the comb (11) to reveal
uneven locks.
Note: Between operations, you can
hang the clipper on the hanging loop (5)
having preliminarily switched the unit off
using the power switch (1).
CLEANING AND MAINTENANCE
Lubricating the blades
Regularly lubricate the blades with the
oil (13) supplied with the unit.
–
Switch the unit off using the power
switch (1) and unplug it.
–
Apply one-two drops of oil (13)
on the teeth of the blades (3, 4)
and the back side of the upper
blade (4), turn the unit on and make
sure that the blades are moving
smoothly.
–
Switch the unit off. Clean the excess
oil with a dry cloth.
Attention!
Use only the oil supplied
with the unit.
DO NOT use vegetable oil, fat, mixture
of oil and solvents for lubrication.
Solvents will evaporate, leaving the
thick oil that may slow down the blades
motion.
Cleaning of hair clipper
–
Switch off and unplug the unit.
–
Clean the blades from the cut hair,
using the cleaning brush (14).
–
Wipe the accessories and unit body
with a slightly wet cloth, and then
dry them with a soft cloth.
–
Put the protective cover (10) on the
blades (3, 4).
VT-2517_100 x140.indd 7
12.01.2018 15:33:43
