Vitek VT-1695 BK, Инструкция по эксплуатации

Страница: 10 / 84

10
ENGLISH
ing, and the symbol (22) and the icon (23) will light
up on the display.
9. Once the set time is reached, you’ll hear a sound
signal and the cooking will start.
10. The remaining cooking time will be shown on the
display.
11. After the end of cooking the microwave oven will
be switched off, the message «End» will appear on
the display (10) and you’ll hear three sound signals.
Note:
•
The current time should be set before the delayed
start time setting.
•
To check the preset delayed start time press the
«Clock/Preset» button (14), the cooking start time
will be shown on the display (10) during 2-3 sec-
onds.
CHILD SAFETY LOCK
•
Locking: press and hold the «Stop/Cancel» button
(15) for three seconds, you will hear a sound signal,
the message
«OFF» will appear on the display.
•
Lock cancel: in lock mode press and hold the
«Pause/Cancel» button (15) for three seconds,
you will hear a sound signal and the message «OFF»
will go out.
CLEANING AND CARE
•
Switch the unit off and unplug it before cleaning.
•
Do not let moisture get on the unit control panel.
Clean the control panel with a soft, slightly damp
cloth and then wipe it dry.
•
Keep the oven cavity clean. If food crumbs or spilled
liquids stick to oven walls, remove them thoroughly
using a damp cloth.
•
If the oven body and the cavity are very dirty, you
can use a soft detergent.
•
Do not use abrasives or wire brushes to clean the
oven from the outside and inside the cavity.
•
Do not let water or detergent get into the air and
steam outlets on the unit lid.
•
Do not use ammonia detergents.
•
Always keep the door clean. Provide that no
crumbs accumulate between the door and the
oven front panel as it prevents the door from nor-
mal closing.
•
Regularly clean the ventilation openings on the rear
side of the oven body from dust and dirt, as air for
cooling of the unit passes through them. To clean
the ventilation openings you can use a vacuum
cleaner with a corresponding attachment.
•
Regularly take out and clean the glass rotary bottom
plate, the roller support and the roller ring; regularly
wipe the bottom of the oven cavity.
•
Wash the glass bottom plate and the rolling ring
with warm water and neutral detergent, then rinse
and dry.
•
Do not immerse the heated glass rotary bottom
plate into cold water, the glass plate can split due to
extreme temperature difference.
•
To remove unpleasant odors in the cavity put a bowl
with water and lemon juice in the oven and boil it for
several minutes. Thoroughly wipe the walls of the
oven cavity with a soft cloth
TROUBLES AND TROUBLESHOOTING
The microwave oven makes interfer-
ences in the reception of TV and radio
signals During operation of the unit interferences in the reception of TV and radio
signals can appear. The same interferences appear during operation of
small electrical appliances such as a mixer, a vacuum cleaner and a hair
dryer. It is normal.
Steam accumulation on the door, hot
air output from the ventilation open-
ings. During cooking, the liquid in the products turns into steam; it will be re-
leased from the ventilation openings; the steam can accumulate on the
inner side of the door, making it misted up. It is normal.
Microwave oven is switched on with-
out food inside. Switching the unit on for a short time without food does not cause its dam-
age. Always make sure that there are products in the oven cavity before
switching it on.
Troubleshooting
Failure Possible Cause Solution
The unit cannot be switched on The power plug is not properly insert-
ed in the socket. Pull the plug out of the socket. After
10 seconds insert the plug into the
socket again.
Malfunction of the electric socket Try to connect another electric unit
to the same socket
No heating The door is not closed tightly Close the door tightly
The glass rotary bottom plate pro-
duces foreign sounds during opera-
tion The roller ring or the bottom part of
the oven cavity is dirty. Remove the glass bottom plate and
the roller ring. Wash the roller ring
and the bottom of the oven cavity.
VT-1695_IM_rus.indd 10 08.07.2013 17:38:31