Vitek VT-1544, Инструкция по эксплуатации

Страница: 4 / 24

ENGLISH
4
•
Do not leave children unattended
to prevent using the unit as a toy.
•
During the unit operation and
breaks between operation cycles,
place the unit out of reach of chil-
dren.
•
The unit is not intended for
usage by physically or mental-
ly disabled persons (including
children) or by persons lacking
experience or knowledge if they
are not under supervision of a
person who is responsible for
their safety or if they are not
instructed by this person on the
usage of the unit.
•
For children safety reasons do not
leave polyethylene bags used as a
packaging unattended.
ATTENTION! Do not allow children to
play with polyethylene bags or pack-
aging film. Danger of suffocation!
•
Check the power cord and
power plug periodically. Do not
use the coffee grinder if the unit,
the power cord or the power plug
is damaged. If the power cord is
damaged, it should be replaced
by the manufacturer, a mainte-
nance service or similar qualified
personnel to avoid danger.
•
Do not attempt to repair the unit.
Do not disassemble the unit by
yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from
the contact address list given in
the warranty certificate and on
the website www.vitek.ru.
•
To avoid damages, transport the
unit in the original package only.
•
Keep the unit out of reach of chil-
dren and disabled persons.
THE UNIT IS INTENDED FOR
HOUSEHOLD USE ONLY, ITS
COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK
SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or stor-
age at low temperature keep it
for at least three hours at room
temperature before switching on.
– Unpack the coffee grinder com-
pletely and remove any advertis-
ing stickers that can prevent its
operation.
– Check the unit for damages; do
not use it in case of damages.
–
Before switching the unit on,
make sure that your home mains
voltage corresponds to the unit
operating voltage.
–
The unit is intended for opera-
tion with AC system and 50 or
60 Hz frequency. The unit does
not need any additional settings
for operating with the required
nominal frequency.
– Unwind the power cord com-
pletely.
–
Remove the lid (3).
– Wash the lid (3) with warm water
and a neutral detergent and dry
it thoroughly.
–
Clean the process chamber (2),
the knives and the body (1) with
IM VT-1544.indd 4 26.12.2018 15:52:49