25
ENGLISH
POWER SCREW
"
The power screw permits you to adjust the power. It
has been adjust before leaving the factory.
However, if the voltage in your home is low, you may
need to reNadjust it.
N
To adjust, use a screwdriver or a thin coin to turn
power screw in clockwise direction until the arm
strikes the coil, making a noise. Then slowly turn
power screw out (counterNclockwise) just until
noise stops. This is maximum power setting.
BLADE LEVER
N
The lever is conveniently located near your thumb
(if you're rightNhanded) so it can easily be adjusted
while the clipper is in your hand.
N
The lever adds versatility to your clipper by allowing
you to gradually change the closeness of your cut
without an attachment comb.
N
When the lever is in the uppermost position, the
blades will give you the closest cut and leave the
hair very short. Pushing the lever downward graduN
ally increases the cutting length.
N
In its lowest position, the lever will leave the hair
approximately
the
same
length as a N1 comb.
N
The lever will also extend the
use of your blades since a difN
ferent cutting edge is used in
each , setting.
4
1352.qxd 07.02.03 11:16 Page 8
