Vitek Transcendent VTC-TNB8RFA3-2, Руководство пользователя

Страница: 47 / 78

40
Network Camera User Manual
Click “Draw Area” and drag the border lines of the rectangle to modify its size. Move the
rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to
clear the area. Then set the detectable face size by defining the maximum value and the
minimum value (The default size range of a single face image occupies from 3% to 50% of the
entire image).
5.
Advanced settings. Choose the snapshot interval and number as needed to avoid capturing
multiple similar pictures in a very short period.
Snapshot Interval: If 5 seconds is selected, the camera will capture the same target once every
5 seconds during its continuous tracking period.
Snapshot Number: If the snapshot number is enabled and set (eg. 3), the camera will capture
the same target once every 5 seconds and it will capture this target 3 times at most during its
continuous tracking period. If the snapshot number is disabled, the camera will capture the same
target once every 5 seconds until the target disappears in the detected area.
6.
Set the schedule of the face detection. The setup steps of the schedule are the same as
schedule recording setup (See Schedule Recording ).
41
Network Camera User Manual
※ Configuration requirements of camera and surrounding area
1. Cameras must be installed in an area with stable and adequate light sources.
2. The installation height ranges from 6 to 12 feet, adjustable according to the focal length of
different lenses and object distances.
3. The depression angle of the camera should be less than or equal to 15°.
4. The object distance depends on the focal length of the lens mounted in the camera.
5. To ensure the accuracy of face detection, the captured faces are only allowed to deviate less
than 30° left or right or 20° up or down.
6. The following scenes are not applicable, like crowded scenes (airport, railway station, square,
etc.), backlight scenes, crossroads and so on.
4.6 Network Configuration
4.6.1 TCP/IP
Go to Config
→
Network
→
TCP/IP interface as shown below. There are two ways for network
connection.
Use IP address (take IPv4 for example)- There are two options for IP setup: obtain an IP
address automatically by DHCP and use the following IP address. Please choose one of the