88
Installation
Before beginning installation, make sure that the wall or ceiling is
strong enough to withstand 3 times the weight of the camera. The
mounting steps are as follows:
Loosen the screws to open
the lower dome and then
loosen the lock screw to
remove the mounting base.
1. Attach the drill template to
the place where you want to
install the camera, then drill
the screw holes and 1 cable
hole according to the drill
template.
3. Route the cables and
connect the power & video
cables, use the rubber plug
to fill the gap of the mounting
base. then secure the
mounting base to the ceiling
or wall with screws.
2. *Unscrew the trim ring by turning it
counter-clockwise. This will enable the
removal of the lower dome.
4. Adjust the Three-axis camer bracket to obtain the optimium
viewing angle.
74.3
74.3
(mm)
INCHES
2.92
2.92
2.92
Trim
ring
Rubber
P
lug
Lower dome
Rotation 0°~355°
Pan 0°~355°
Tilt 0°~67°
5. Install the dome bubble on
the camera with the screws,
then replace the trim ring
by turning it clockwise.
Finally, carefully remove the
protective film to complete the
installation.
