MGW Ace Decoder
HEVC Decoding Appliance
User Manual, Version 1.0
34
Parameter
Description
Management Access
Select the Ethernet Port used for management
(Ethernet Port 1, 2 or 1&2)
IPv4 Address Type
Select either Static, DHCP, or DHCP+Zeroconf
Zeroconf allows the unit to get an IP address
automatically without DHCP server on the
network.
To retrieve the system IP address, refer to
section
Retrieving or Setting Network
Parameters through a USB Thumb Drive
(on
page 13) for more information.
IP Address
Enter IPv4 Address if Static mode is selected
Subnet Mask
Enter Subnet Mask if Static mode is selected
Default Gateway
Enter default Gateway if Static mode is
selected
IPv6 Address Type
Select either Static, Statefull or Stateless
IPv6 Address auto/prefix
Displays the IP/Prefix address.
IPv6 Address manual/prefix
Enter a static IP/Prefix address.
Default Gateway
Select which Ethernet port settings to be used
as the default gateway.
NOTE
:
You must click
Apply
for the new settings to be saved.
To set SAP:
Parameter
Description
Use default SAP
address and port
Use the default Session Announcement Protocol multicast group
and port as per
RFC 2974
.
Interface
Select which Ethernet interface listens to the SAP.
IP Address
Set the target multicast IP address to which SAP messages will be
sent.
Port
Set the target port to which SAP messages will be sent.
