The Touch & Go
®
Blending Station
®
advanced electronic control can be custom programmed,*
requiring an optional programming chip, available from Vita-Mix for a nominal fee and with a
minimum unit purchase. Contact your Vita-Mix representative for more information.
Programming your On-Counter Touch & Go
Blending Station PRE-SET buttons
1. Turn the machine on.
2. Facing the front of the machine, insert the custom pro-
grammed chip with the words, “THIS SIDE FACING TO THE
FRONT OF THE MACHINE” toward you and the silver contact
bars up, into the port located below the label area on the front
of the Touch & Go Blending Station. The DISPLAY WINDOW
will read ‘New Module’.
3. Within 10 seconds the SIX PRE-SET buttons will be re-
programmed and the DISPLAY WINDOW will read ‘Saved’
then ‘Ready’. If nothing happens when the programming chip
is fully inserted, turn the chip in the opposite direction and
try again.
4. Remove the programming chip and return it to the original package.
5. Press one of the six PRE-SET buttons to reveal, in the DISPLAY WINDOW, the name of
the program/drink.*
NOTE:
If for any reason the programmed times are incorrect, they can be reset to the origi-
nal factory settings following the instructions on page 7.
Programming your In Counter Touch & Go
Blending Station PRE-SET buttons
1. Remove the container from the machine.
2. Turn the machine on.
3. Lift the machine from the bottom edges to reveal the motor and housing area. With the
machine facing towards you, locate the slot underneath on the right hand side of the
machine between the motor and the outer wall.
4. Insert the custom programmed chip into the slot with the words, “THIS SIDE FACING TO
THE FRONT OF THE MACHINE” turned facing out to the right of the machine. Once inserted
the DISPLAY WINDOW will read ‘NEW MODULE’.
C
ustom Programming
Custom
Programmed
Chip
6
