5. Once one of the six PRE-SET PROGRAM buttons is pushed the machine will start and
stop automatically. By pressing another PRE-SET BUTTON or the START/STOP button,
the machine will stop the blending cycle.
6. During any of the blending cycles, by pressing the PULSE H button the speed of the blending
can increase up to 100% of the motor speed. By pressing the PULSE L button during a
blending cycle the speed of the motor can be decreased down to 7%. Once released the
motor speed will revert back to the blending cycle of the PRE-SET PROGRAM.
(
NOTE:
Use the SPEED CONTROL buttons to set the speed of the PULSE buttons. For
example, when the H or L PULSE button is pressed and held, by simultaneously pressing and
holding the
▲
or
▼
SPEED CONTROL button the motor speed will increase or decrease in 1%
increments. When the SPEED CONTROL button is released, the PULSE button will remain set
at the selected speed until altered with the SPEED CONTROL buttons.)
7. When the cycle is complete the blender stops,
wait until blade comes to a complete
stop before removing the lid and/or container from the motor base.
8. Remove the container, pour, garnish and serve the drink.
How to operate your Blending Station
®
using the
Start/Stop and Speed Control button.
Although using the PRE-SET PROGRAMMED buttons is highly recommended for the best
drink, occasionally a drink may need special attention. By using the START/STOP button and
the SPEED CONTROL button you can manually control the speed of the Blending Station.
1. Follow steps one through three of ‘How To Operate Your Blending Station Using The Six
Pre-Set Programmed Buttons’ section on page 14.
2. The speed of the motor can be changed with:
3. The PULSE buttons can also be used to quickly increase the motor speed or decrease the
motor speed. (See HIGH/LOW PULSE button description on page 5.)
4. When done blending press the START/STOP button to stop the motor.
Wait until blade comes to a complete stop before removing the lid
and/or container from the motor base.
5. Remove the container from the motor base and serve the drink.
NOTE:
On all units the built-in thermal sensor keeps track of how hot the motor gets and will
warn the user and eventually shut down the motor if the motor is overheating. When overheated
the display will instruct the user to remove the container and run the machine until cool. This
takes about a minute. See page 21, “Cooling the motor,” for complete instructions. See page 13
for Blending Tips to avoid overheating the motor.
15
• the motor off.
– Press the
▲
or
▼
buttons until the
desired speed percentage is displayed.
100% is the highest setting and 7% is
the lowest setting.
– When the START/STOP button is
pressed the motor will ramp quickly to
that speed
– Blending can be stopped by pressing
the START/STOP button at any time.
• the motor on.
– With the container in place press the
START/STOP button. The machine will
begin blending.
– While the machine is running Press the
▲
or
▼
buttons until the desired speed
percentage is displayed. 100% is the high-
est setting and 7% is the lowest setting.
– Release the SPEED CONTROL button
and the motor will now run at the desired
speed.
– The blending can be stopped by pressing
the START/STOP button.
