Page 14
Section 4.5 PTO LINKED WITH CUSTOM RPM CONTROL
When PTO Control is linked with Custom RPM Control (PTO/CUSTOM RPM LINKED), the PTO and Custom RPM
Control operate together. This feature requires programming and remote switch installation.
This feature is useful for applications when it's necessary to turn on the PTO and elevate idle from a
remote location on the vehicle.
Additionally, with this function programmed, you can turn off the PTO, adjust the
idle speed, and return to normal idle. This function is possible because it is not necessary to press the [RPM
CONTROL] key or the [PTO CONTROL] key on the module inside the cab.
Step 1 Program the module for PTO Linked with CUSTOM RPM CONTROL.
1. Go to main programming mode, press and hold [RPM CONTROL], [CHARGE PROTECT] & [FORD]
keys
2. Menu 1 should be set to "
BASE
" mode.
3. Go to Menu 2 by pressing the [FORD] key. See "RPM" and "PTO" on the right hand side.
4. Change the mode from "no" to "
Yes
" by pressing any [ARROW] key.
5. Press [Ford] key. Menu 3 shows the programmed PTO Lower Limit.
6. Press [Ford] key. Menu 4 shows the programmed PTO Upper Limit.
7. Menu 5 should be set to "
CUSt
" mode. Press [Ford] key to exit.
NOTE: Automatic RPM Control is not available with PTO/RPM LINKED.
Step 2 Initiate PTO Linked with CUSTOM RPM CONTROL mode.
•
The RPM Control light will turn on steady automatically when Custom RPM Control mode is
programmed.
» RPM value associated with the Custom Input Voltage is displayed
⇒
If within range (0.5 to 4.5 Volts), display shows value of engine speed according to
voltage input
⇒
If input is below or above voltage range, display shows "OFF"
Step 3 Activate the Custom RPM Control mode. PTO output will also be activated.
•
Press
[FORD]
key or installed Remote FORD switch to activate RPM Control mode
» RPM Control Light will flash
» Engine idle is elevated to the RPM value associated with input voltage
» Current engine speed is displayed
Exiting PTO/CUSTOM RPM LINKED
ANY ONE of the following will exit Custom RPM Control and return engine to normal idle.
•
Press Remote FORD switch *
•
Press [FORD] key *
•
Press [PTO CONTROL] key
•
Out-of-range Custom Voltage Input (<0.5V or >4.5V)
•
Press [POWER] key
•
Press [RPM CONTROL] key **
•
Press brake or clutch pedal, take vehicle out of park, or release parking brake
* Press [FORD] key to re-activate PTO/Custom RPM Control mode.
** Pressing the [RPM CONTROL] key will exit Custom RPM mode until the next key off/key on cycle.
PTO/RPM Control mode (Section 4.4) can be activated by pressing the [RPM CONTROL] then [FORD] key.
