8
Installation Guide & Owner’s Manual
TM
1” minimum
Hot
Cold
Plumbing
Whether installing a single or double-autoclave VistaCool unit, the cold water (coolant) supply and drain
(condensate and coolant overfl ow) connections are exactly the same�
NOTE:
When installing the black 1/4” OD condensate line with a V7501 system, make sure to install the white 1/4”
plug in the remaining open fi tting on the adapter to prevent water from fl owing out of the drain� When
installing a V7502 system, connect a black condensate line to each of the two 1/4” push-to-connect
fi ttings and set the white plug aside�
Turn off water supply� Tap the cold water line with a
tee, valve, compression valve, etc� (not included)� The
connection must be made by the installer so the 1/4”
O�D� polyurethane tubing can be connected�
Cut a 3” to 4” piece of the blue poly tubing and connect
the installed fi tting (from step 1) to the inlet of the inline
water valve provided� Be certain the valve is in the closed
position (blue lever 90-degrees to the valve body)�
Cut another 3” to 4” piece of blue poly tubing and
connect one end to the outlet end of the inline valve,
and the other end to the inlet of the supplied CSA-
certifi ed VistaCheck dual check backfl ow preventer�
1
2
3
To Coolant Overflow
Barb on Top of Tank
Always slope lines
downward
toward drain.
To VistaCool Manifold
1
2
3
A
A
B
B
S6130P
Plug
Connect VistaCool to cold water supply ahead of foot switch (if present) for uninterrupted water supply!
4
Measure the drain tee adapter
assembly for placement into the
drain piping� Cut and remove
a section (usually 1-1/2”) in the
appropriate place above the trap as
shown� Keep the entire assembly as
low as possible while maintaining a
minimum of 1” off set from the barb
fi tting as shown� Rotate the drain
adapter hub so the barb fi tting is at
the 6:00 position�
Be sure to tighten slip-joint tee’s
nuts once all steps are complete�
4
