vistaCNC iMachIII P4-S, Руководство пользователя

Страница: 12 / 14

www.vistacnc.com
- 12 -
www.vistacnc.com
- 12 -
iMach
III
P4-S Pendant Manual v. 4.0
5. E-Stop switch button
5.1 E-Stop switch button in P4-S model

Press E-STOP switch button to send out E-Stop signal to Mach3 application and activate
Emergency Mode in Mach3.

When the button is pressed, the switch is locked down. Twist the button to reset the button and
reset E-STOP.
5.2 E-Stop switch button in P4-SE model

Press E-STOP switch button to send out E-Stop signal to Mach3 application and activate
Emergency Mode in Mach3.

The same E-stop signal is simultaneously sent out through a 2-wire loop, which can be used to
control a relay or to connect with other E-stop buttons.

When the button is pressed and the switch is locked down, the 2-wire loop is open.
 Twist the button to reset the switch and reset E-STOP signal, and at the same time, the two
wires are connected at the switch end and form a closed loop.

A EE box is needed as an interface to separate the 2-wire loop and USB signal.