vistaCNC iMachIII P1A-S, Руководство пользователя

Страница: 9 / 10

www.vistacnc.com
- 9 -
www.vistacnc.com
- 9 -
iMach
III
P1A-S Pendant Manual v4.0.0
5.2 E-Stop switch button in P1A-SE model
 Press E-STOP switch button to send out E-Stop signal to Mach3 application and activate
Emergency Mode in Mach3.
 The same E-stop signal is simultaneously sent out through a 2-wire loop, which can be used to
control a relay or to connect with other E-stop buttons.
 When the button is pressed and the switch is locked down, the 2-wire loop is open.
 Twist the button to reset the switch and reset E-STOP signal, and at the same time, the two
wires are connected at the switch end and form a closed loop.
 A EE box is needed as an interface to separate the 2-wire loop and USB signal.
E-STOP switch and EE box connection in P1A-SE