12 D-304267
PowerMaster-33 G2 Installer's Guide
3.6 PGM-5 Installation
(located in place of detail "E" in Figure 3.1)
PGM-5 is an output interface module designed to provide alarm, trouble events and status signals to external devices
such as long range wireless monitoring transmitters, CCTV systems, home-automation systems and LED annunciation
panels (for further details see the PGM-5 Installation Instructions).
The PGM-5 provides 5 solid state relay contact outputs and is designed to be used as a plug-in internal add-on module
with the PowerMaster-33 G2 control panel.
Mount the PGM-5 module as shown in Figure 3.6.
1.
Press downward on the PGM-5 module (D), located in the back panel, between its 2 clips.
2.
Connect the PGM-5 module flat cable (F) to the front panel PGM-5 receptacle and to the flat cable receptacle of
the PGM-5 (G).
Caution!
The connector with strain relief clip (F1) is for the front unit – do not connect it to the back unit!
Notes:
The PGM-5 will be active only if the PGM-5 option was enabled in the control panel (see section 4.7.6, “PGM Output
Configuration”.
For wiring instructions, refer to the PGM-5 Installation Instructions included in the module's package.
Caution!
When mounting the PGM-5 module it is strongly recommended to route the wiring cable (E) as shown in
Figure 3.6) to prevent interference which may occur if routed too close to the control panel antennas.
A.
PowerMaster-33 G2 connector
B.
Front unit
C.
PGM-5 Module
D.
Back unit
E.
Wiring Cable
F.
Flat cable
F1.
This side for front unit
F2.
This side for back unit
G.
PGM-5 flat cable receptacle
Figure 3.6 – PGM-5 Module Mounting