PLTX Digital Power Amplifier User Manual
Installation Requirements
Issue No: 01
Page: 11
Ref: PLTX-ASUM-7xxx
Copyright © 2017 IMT Ltd, trading as Vislink
Should you need to make any user-changes to the unit, ensure you read and understand
the following warnings and cautions.
CAUTION: Vislink strongly recommend returning any equipment requiring RF servicing to
the factory.
CAUTION: During the insertion or removal of interface connectors ensure that the
connectors are free from debris and be sure not to damage the contact pins.
WARNING: Switch off power supplies before removing covers or disconnecting any RF
cables, and before inspecting damaged cables or antennas.
WARNING: Avoid standing in front of antennas fed by high power amplifiers and never look
into the open end of a waveguide or cable where RF power may be present.
WARNING: Wipe off any water or fluids immediately.
WARNING: Do not open or modify the assembly.
1.
Refer to Section 6.1 above regarding handling precautions.
2.
Secure the unit using the mounting holes in the interface plate at the base of the
unit.
NOTE: Orientation of the unit is non-specific for operation.
CAUTION: The unit is fitted with a cooling fan integrated into the heat sink. Adequate free
air circulation is required around the unit to allow the fan to dissipate heat
generated by the amplifier.
CAUTION: Do not block the air inlet or exhaust ports. Ensure there is sufficient clearance to
allow free air circulation.
NOTE: See Section 3 (Specifications) for power consumption information.
CAUTION: The unit is designed to be splash proof (Rated to IP55). To prevent water ingress,
do not allow the unit to sit in a pool of water deeper than 90mm.
