HHT3 Operators Manual
Configuring the Receiver
Issue :No. 7b
Page : 13
Ref: HHT3-ASUM-7000
Copyright © 2018 IMT Ltd, trading as Vislink
To turn the unit on, press the non-locking on/off button on the front panel, holding down
for one to two seconds until the LCD screen illuminates and the unit begins to power on.
To turn the unit off, press the non-locking on/off button on the front panel and hold down
two to five seconds, until the unit powers down.
Use the LCD display and six push buttons to configure the Handheld. The buttons are
arranged as four navigation buttons (
▲▼◄►
) OK and ESC (escape) selection buttons.
The OK button is used to store a modified parameter in non-volatile memory; this
parameter will then be used to configure the Handheld receiver and becomes the default
value when next powered on. The ESC button can be used to exit a menu without storing
the parameter in memory.
Received video picture monitoring is available on the full color front panel LCD screen.
To access the function, press any control key.
These screens show the units status and any alarms.
To navigate between the status and alarm screens, press the ESC button several times to
reach the overview screen and use the
►
button.
Figure 5-1
Overview Screens
The overview screen is shown during normal operation of the Handheld receiver and
indicates the Channel number and Rx frequency. Provided the receiver is receiving a signal
from the transmitter, the display will show the modulation, the spectrum bandwidth and
the receiver input levels for the two antenna inputs.
