Page 5
HDE-264 HD/SD Encoder User and Technical Manual
Quick Start (Portable Operation)
Complete the following steps:
Connect your camera or other video signal source to suitable 75 Ohm BNC
connector cable and connect to encoder rear panel
Video IN 1
or
2
input
connector.
Verify that the
DC Power In
cable from your +22 to +2 VDC Power Supply is
connected to the rear panel
DC Power In
4-pin Lemo connector. There is no
ON/OFF Switch (in Portable configuration) so Power is ON when DC Input is
connected. Allow 60 seconds for the encoder to fully start-up. The front panel
display will show
Vislink - Encoder Bootup Process
during start-up.
Verify that at least one of your rear panel
ASI OUT
connectors is connected to a
suitable 75 Ohm BNC connector cable and to your destination point (transmitter
input eg.). Or, if you are streaming IP out to Ethernet, ensure that you have a
suitable network cable connected to the rear panel RJ-45
Ethernet
port and to your
destination point (PC LAN Port eg.).
Verify that your audio connections are made to the rear panel
L
and
R
Audio OUT
XLR connectors (if audio is required).
Select your desired Preset using the
Preset
and
UP/Down
keys on the Main
Control Panel (see Main Control Panel section). Press the
Save
key.
If required, refer to
Web Browser Control Interface
section for Preset configuration
instructions.
1.
2.
.
4.
5.
6.
Main Control
Panel
(Top, Portable
Unit)
Front Panel
(Portable Unit)
Rear Panel
(Portable Unit)
