Guide DF Integration
Issue No: A
Page: 12
Ref: DragonFly Installation Guide
Copyright © 2020 IMT and Vislink are Vislink Technologies Inc. companies
3.6.
Physical Installation
The OEM DragonFly Chassis model uses the 4 2-56 threaded screw holes on the bottom of
the unit to fasten to the installation location that is conducive to thermal dissipation. A
thermal pad is supplied with the OEM DFC Kit to help in the thermal transfer from the device
to the installation location.
1)
Define the installation location
a.
Make sure clearances are good.
b.
Make 2-56 through holes matching the outline drawing above or using the
.stp files as a reference.
2)
Place the thermal pad to align the through-holes with pattern in the DragonFly.
3)
Fasten DragonFly in place using 4 2-56 screws supplied in the kit, or chose to fit.
4)
Make or purchase cables need to run DragonFly. The following cable is needed to
be made:
a.
Power and RS 232 serial cable
b.
SDI cable
–
A SDI to BNC cable is supplied in the kit
–
however, a custom
one may be bought or made depending on needs.
c.
Camera control
–
A 20-inch cable is supplied with the mating connector of
the CC connector. The other end is bare tinned leads and may be used to
attach directly to the camera or interface connectors that go to the camera.
d.
Antenna extension cable
–
purchased or made.
Figure 3-3: OEM DF Chase Installation
