IF YOU REQUIRE AN ADDITIONAL CAMERA OR CABLES, PLEASE CONTACT YOUR
LOCAL VISION WORKS DEALER
Connect
VIDEO EXTENSION CABLE
harness to C1 input on
MAIN HARNESS
.
Ensure arrows are aligned on outer jacket of
cable ends.
Turn silver cable connector nut clockwise to
secure the connection of the cables.
Do not over tighten. Pull rubber sleeve
membrane over cable connection. Ref. Fig.2
Connect other end of
VIDEO EXTENSION CABLE
harness to
CAMERA
harness cable. Again, ensure arrows
are aligned on outer jacket of cable ends. Turn silver cable connector nut clockwise to secure the connection
of the cables. Do not overtighten.
Ref. Fig.2
The
MAIN HARNESS
included in this kit contains two video cable inputs. The cable input labelled C2 can be
used to accept a video signal from a second optional camera. C2 imaging can be selected from the remote
(Video Select) or monitor (V1/V2) controls. It will also activate and provide a video feed to the monitor if
12VDC power is supplied to the GREEN wire on the
MAIN HARNESS
.
Note:
A common application for the C2 video feed is for rear view imaging when in reverse. For C2 video feed
for a reverse application, it is common to connect the GREEN wire to the reverse wire on the vehicle.
Ref. Fig.2
Included in kit is an
AV Accessory Cable
adaptor that will allow you to play videos from a DVD
player or alternate video source. It can be installed into C1 or C2 monitor inputs.
4
