© 2018
Step 3 of 3
Order #XXXXX
Completed Assembly
Back View
Counter Top
Counter Top
Shelf
Shelf
Transformer
Transformer
Steps:
1) Connect lighting power cords and attach
transformers. See
Light to Light Connection
&
Light to Transformer Connection
details.
2) Pla
ce Shelves o
nto pins. See
Shelf Pin
detail.
3) Place Counter Top on top of assembed counter base.
See
Counter Top Attachment
detail.
4) Install SEG graphics to front of assembled frames.
Se
e
SEG Graphic Installation
detail.
BACK VIEW
FRONT VIEW
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
SEG Graphic Installation
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
*
*
*
*
*
*
*
*
SEG G
raphic
SEG G
raphic
Shelf Pin
1) Slide pin into groove
of Vertical Extrusion.
2) Use hex tool to
tighten pin in place.
Pin
*
Align hole with pin
Rotate pin. Spring
will push pin into hole.
Counter Top Attachment
1
2
*
Pin
Hole
+
+
+
-
-
-
to power
Lights
Male
Male
Female
Female
Transformer
Light to Light Connection
Light to Tranformer Connection
Counter Attachments (Cont’d)
