Introduction
Thank you for choosing Visionary International as your lighting provider. This operating manual
provides information on how the product functions and how to safely operate and install the
product.
Installing the product (Existing installation)
Any electrical work must conform with the Electricity Act 1992 including section 79,
NZECP 50: 2004, Electricity Act 1992 Section 80 and NZECP 51: 2004.
1) Disable power to the circuit that you are working on. We highly recommend switching elec-
tricity off at the main switchboard of the premises for added safety.
2) (If applicable) Remove the previous fitting from the ceiling being careful not to damage the
ceiling material. Ensure that there is no remaining driver/transformer connected to the specific
lighting mains cable.
Hook Mounted Installation
A) Apply the ring mount to the rear of the LED driver unit, ensuring the the spring is applied on
the screw part of the ring mount prior to connection. The spring helps to ensure that the ring
mount does not dislodge over time.
B)Tightly fasten the ring mount until very firm. We suggest using a large screw driver, applied
to the inside of the ring as a leverage tool to fasten at tightly as possible.
C) Connect the ring mount to the cable or d-Link and hang accordingly.
Bracket Mount Installation
A) Prepare the installation surface and ensure that it can support at least 10x the weight of the
LED highbay (7kg Max) = 70kg load requirement. Each Screw anchor should be capable of
holding at least 50kg of weight and at minimum of two anchor points should be used on the
bracket.
B) Using the bracket as a template, add screws to bracket using spacing as per the diagram
above.
3) Plug the 3-Pin NZ/AU plug into a surface or recessed mounted socket. Once securely plugged
in, re liven the circuit.
