Vision VE-810, Руководство по эксплуатации

Страница: 35 / 69

Chapter 3 - Operations 35
You can use either double-sided tape, the ”MultiMat“ hold down material, or the quick lock
vise to hold down material to the T-slot table. (There are other types of optional hold
down methods explained in Chapter 4.) You can get double-sided tape or the ” MultiMat “
material from your Vision Distributor or Vision. The quick lock vise is included with the
VE-810. (See figure 3.1 for an example of using the quick lock vise.)
(Figure 3.1) The Quick Lock
Vise
Put the material you would like to engrave on the T-slot table and push it to the home
position corner (Fig 3.1). Next, loosen the quick lock vise locking screw and slide the
quick lock vise so that there is about 1/16 of an inch gap between the edge of the vise and
the material. Tighten the quick lock vise locking screw. Once this is done, the material
can easily be tightened up by turning the quick lock vise handle. When you want to
change the engraving material, simply loosen the quick lock vise handle, remove the
engraved material, put the new material in and tighten up the quick lock handle.
Note: For larger pieces of material, you may need to put a small piece of double-sided
tape on the T-slot table in the middle of the engraving material. This will keep the material
from bowing in the center.
The quick lock vise will only work on square or rectangular material. To hold down
irregular shaped objects, you must use some other method. Ask your Vision Distributor or
Vision if you need more information on this feature.
Edge guides:
The T-slot table edge guides need to be adjusted to the thickness of
material that you are engraving. If they are not adjusted properly, the machine may not
engrave the letters completely. See figure 3.2.