Vision.net 63060CM, Руководство по установке

Страница: 12 / 16

Installation & Operation Guide
Vision.net Photocell Daylighting Sensor
10
Step 4a. When the Sunlight is at its Low Level (early morning or late evening), Press and
Hold the LSUN (1) button for 3 or more seconds. Release the button when the
Photocell Sensor goes blank. After 5 seconds the Sensor will take a Snapshot of the
room and set the Low Sunlight Setting.
A – The Sunlight Setting can be modified by Tapping the –SUN (5) button to
decrease the level in 5% increments (max is -80%).
B – The Sunlight Setting can be set back to its Snapshot Level by Tapping the
=SUN (6) button.
C – The Sunlight Setting can be modified by Tapping the +SUN (7) button to
increase the level in 5% increments (max is +100%).
Step 4b. When the Sunlight is at its High Level (mid-day), Press and Hold the HSUN (2)
button for 3 or more seconds. Release the button when the Photocell Sensor goes
blank. After 5 seconds the Sensor will take a Snapshot of the room and set the High
Sunlight Setting.
A – The Sunlight Setting can be modified by Tapping the –SUN (5) button to
decrease the level in 5% increments (max is -80%).
B – The Sunlight Setting can be set back to its Snapshot Level by Tapping the
=SUN (6) button.
C – The Sunlight Setting can be modified by Tapping the +SUN (7) button to
increase the level in 5% increments (max is +100%).
Testing Daylight Harvesting
Step 1. Tap TEST button to put the system in TEST Mode. All Sensors will start flashing
once every few seconds. The color of the Photocell Sensor will be based on whether
it is sensing Sunlight below the Low Sunlight Level (Red), between the Low and
High Sunlight Levels (Green), or above the High Sunlight Level (Blue). The control
of the RLYS Buttons and Dimmers will be accelerated during Test Mode.
Step 2. While in test Mode the sensed Sunlight can be electronically adjusted by tapping
the –SUN (5) to reduce it in 5% increments, =SUN (6) to return it to actual level,
and +SUN (7) to increase it in 5% increments. This allows the Photocell to be
tested (observe the colors) without waiting for the actual sun to change.
Step 3. Tap TEST button a second time to go back to Parameter Setting Mode.
Note: Refer to page 7 for Programmer Remote button layout.