Page
9
/
15
Installation Camera with Brackets
Installation using Ceiling Mount Bracket
①
Remove the ceiling tile from the ceiling and cut
a hole whose diameter is 30~40mm on the ceiling
tile to pass the wire(s) and cable(s) through to the
upside of the ceiling. (In case of the wiring and
cabling through the mounting surface only) Then
prepare the ceiling mount bracket. Pull the wire(s)
for the system as below. (Anchor Bolt 3/8"
×
70)
②
Hook up “Drop Prevention Spring” on main
body to prevent camera from unexpected drop
and pull the wire(s) and cable(s) for the system
as below
③
Line up the mold lines and assemble main
body to mount adaptor and turn it. And
assemble the main both with the camera
mount adaptor with the screws. (Torx screw
M4X18). Please make sure the screws are
tightly assembled for waterproof.
④
Screw the dome cover to the main body and
remove the protection vinyl from the dome
cover.
Notice
z
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
z
To adjust the installation height from the mounting surface, the pipe and coupler should be
needed between the surface mount part of the ceiling mount bracket and the camera mount part
of the ceiling mount bracket. Note that they are not supplied by the manufacturer.
