15
Press and hold the Settings button for 3 seconds to set the time and date. Press the
–
button to set the
hour. Press the + button to set the minute. Press the Calendar button to set the day. Press the Enter
button to save the setting. Note: settings will not be saved without any operation within 10 seconds.
Press and hold the Settings button for 6 seconds to set the weekly timer.
Press
–
or + buttons to choose the time period. 5 periods can be selected.
Press the timer button to set the weekly timer start time
–
‘ON’ will flash on the screen. Press –
to set
the hour and press + to set the minute. Press again to set the weekly timer end time
–
‘OFF’ will flash
on the screen. Press
–
to set the hour and press + to set the minute.
Press the Heater Mode button to set the desired temperature setting (from 16-28°C)
Repeatedly press the Calendar button to set the week. Press to save the week settings. Press
to cancel.
Press the Settings button to save the above setting.
IMPORTANT: ALWAYS DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY AND ALLOW
TO COOL BEFORE CLEANING.
Any repairs or maintenance should only be carried out by a suitably qualified competent person.
The appliance should be occasionally cleaned using a dry cloth. Do not use detergents, abrasive cleaners
of furniture polish.
To clean the glass, use a lightly damp cloth and ensure any moisture is dried fully using a lint free cloth.
Ensure that the heater vent is kept dust free by occasionally vacuuming the area using a brush attachment.
Resetting the Thermal Cut Out
The appliance is fitted with an Electronic Safety Control (E.S.C.).
This is a safety device which switches off
the fire if, for any reason, the appliance overheats, e.g. when covered.
If the heater stops operating while
the fl
ame effect continues working normally, this indicates that the E.S.C. is in operation. The E.S.C. can
only be reset after the appliance has cooled down and the appliance has been reset. Re-setting of the
E.S.C. procedure is as follows:
1.
Switch off the appliance (Manual On/Off switch) and leave it off for approximately 10
-15 minutes.
2. Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power supply is
OPERATION
SETTING DATE AND TIME
SETTING WEEKLY TIMER
CLEANING & MAINTENANCE
TROUBLESHOOTING
