13
Ensure that 2 AAA batteries are inserted into the
remote control handset. The battery power level is
indicated by the column of bars to the right side of the
temperature display when the appliance is in standby
mode. 5 bars indicates the batteries are full, 1 bar
indicates the batteries are empty and need to be
replaced immediately.
Remote Control Setup
Press and hold the Illumination On/Off button on the
appliance until you hear two beeps, release the button.
Press Standby button on the remote control handset
and you will hear one beep. The remote is connected
with the appliance.
Button 1: Favourite Mode
Press and hold for 3 seconds to store the current flame
and fuel bed colour settings. Press again to revert to
these settings.
Button 2: Standby
Turns on the appliance with the last used settings
without any heat. Places the appliance into standby
mode with all features turned off.
Button 3&8: Minus & Plus
Use to navigate through different on-screen menus.
Button 4: Fuel Bed Colour
Repeatedly press to cycle through fuel bed colour menu. Whilst in the fuel bed colour menu, press the plus
and minus buttons to increase and decrease the fuel bed brightness - 1 bar is the dimmest setting, 5 bars is
the brightest setting.
On screen Fb.0 = Flame off
On screen Fb.1 = Red
On screen Fb.2 = Orange
On screen Fb.3 = Yellow
On screen Fb.4 = Green
On screen Fb.5 = Light Blue
On screen Fb.6 = Dark Blue
On screen Fb.7 = Violet
On screen Fb.8 = White
On screen Fb.9 = Multi-colour change
FIG. 19
OPERATION
REMOTE CONTROL
