OPERATION
www.visioneng.com/support
10
Crosshair: Long / Short
Select the Crosshair size – Short or Long.
Select the crosshair colour
Cross Col: White / Green / Blue / Red / Yellow / Purple
/ Cyan
Bright: Levels 1 – 15
The image brightness can be adjusted to suit your
preference.
White Balance: On / Off
Turns the auto white balance on / off.
Focus: Manual / Auto
Select between manual and auto focus modes. When
manual focus is selected EVO Cam’s internal focus is
fixed - use focus control on the microscope stand to
adjust focus in this mode.
Infrared: On / Off
Normally the system filters out Infrared light.
Turning the Infrared On allows this spectrum of light to
pass through to the camera.
When the Infrared mode is turned on the image
becomes black and white.
Cam WDR: Off / WD / VE
The Wide Dynamic Range mode is a function for
dividing an image into several blocks and correcting
blocked-up shadows and blown-out highlights in
accordance with the intensity difference.
It enables you to view images with large intensity
differences.
WD
– Images with Wide Dynamic Range are re-
produced by combining long exposure signals with
high-intensity signals obtained with short exposure.
VE
– Using the Visibility Enhancer function will make
the darker part of a camera image brighter as well as
automatically correct brightness and contrast to show
parts clearly without overexposure.
Pick the option which shows the best results in your
application.
Noise R: -3 to 2
The Noise Reduction function removes noise to provide
clearer images.
Screen Size: 7 – 100
Enter the size of your display in inches (Measured
Diagonally) . This size is used to calculate the
magnification levels.
Lens Power: x0.45of, x0.62of, x1.0of, x0.45ff,
x0.62ff, x1.0ff, x1.0av, 4 dioptre, 5 dioptre
Enter the Lens power / dioptre number of the lens to be
used. This is used to calculate the magnification levels.
‘of’ is short for Optimal Field, ‘ff’ is short for Full
Field and ‘av’ is short for All-round View
Unit: Metric / Imperial
Select the units for cursor and grid measurements.
Show OSD: On / Off
Turning the On Screen Display (OSD) off removes all the
static messages from the screen. The menu will still be
displayed when the menu mode is entered.
Time: xx:xx
Enter the current time starting with minutes and then
hours.
Time and Date are only used to Date Stamp the
captured images.
Date: xx/xx/xxxx
Enter the current date starting with day, month and
then the year.
Time and Date are only used to Date Stamp the
captured images.
Rev: xxxxxxxxxx
Displays the firmware revision number of the system.
This may be required for support issues.
