10-
Fixture Hours
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button
and the display will show the number of working hours of the unit. To go back to the functions press the
MENU
button.
Software version
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button
and the display will show the version of software of the unit. To go back to the functions press the
MENU
button again.
4.
How TO Control The Unit
You can operate the unit in two ways
：
1.
By master/slave built-in preprogram function
2.
By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be
effected at once. Every time you turn the unit on, it will show
on the display and move all the
motors to their ‘home’ position. After that the unit will be ready to receive DMX signal or run the built in
programs.
4.1
Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an instant
show. You have to select
(show 1) or
(show 2) ……or
(show 19, show17~19 have
to be edited by the user) show for the first unit. Its DMX input jack will have nothing plugged into. The
other units will be slave mode automatic.
4.2
DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512 channel
so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and
the display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once the address has
been selected, press and keep
ENTER
button pressed up to when the display stops blinking or storing
automatically 8 seconds later. To go back to the functions without any change press the
MENU
button
again.
UnRegister
ed
