Viscount Allegro, Руководство по эксплуатации

Страница: 16 / 30

Viscount Allegro
38
been made, if the status is ON, the LED will
remain on or two seconds as will that
of the [EL.BASS-VOICE SPLIT] key. These
LEDs will then go out, leaving the LED of the
[FUNCTION] key flashing.
3. Set a new split point.
To set a new split point, press the
[EL.BASS-VOICE SPLIT] again,
simultaneously with the keyboard key where
you wish to set the new split.
The LED of the [EL.BASS-VOICE SPLIT]
key and that of the [PIANO 1-ON/OFF] key
remain on for two seconds, after which only
the LED of the [FUNCTION] key will flash.
It is also possible to set a split point if a bass
timbre is being used. The procedure is the
same as that for two voices.
When the operation is complete, press the
[FUNCTION] key again, or the key of a new
function.
N.B.: When setting the split both for the
voices and for the bass timbre, the keyboard
key pressed must be in the part on your left.
The SECTION VOLUME function allows the user to set the volumes of the voices being played,
without distinction. When the timbres selected are changed, the volume levels remain the same as
those of the previous voices set; this might cause unpleasant combinations. To avoid this, and to
set new volume levels, proceed as follows:
$
$% $% &
Activate the new function and set the new
volume level.
Press the [FUNCTION] key, and when its
LED flashes, press the key relative to the
timbre the level of which you wish to set.
The keys are assigned to the timbres as
follows:
-
[PIANO] 1 key: 1st VOICE section;
- [PIANO] 2 key: 2nd VOICE section;
- [EL.PIANO] key: BASS section.
After the setting has been made, the LED
of the key which was pressed will start to
flash for two seconds and in alternation
(every two seconds) the current volume will
be displayed by means of the eight function
keys, starting from the LED of the [PIANO 1]
(minimum volume) key down to the [EL.ORGAN] (maximum volume) key. Once the desired
volume has been selected (by pressing the key the LED of which displays the desired level), only
the LED of the [FUNCTION] key will keep flashing. To exit from the function, press the
[FUNCTION] key again, or to access another function, press its key.