ViscoTec Preeflow eco-PEN700 3D, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 32

15 / 32 INST-002756 / A eco-PEN700 3D
Version B
(e.g. open cartridge, dispenser fixed in place and supply of the material under pressure)
Tip: Alternatively, the air can also be extracted from the pump area with the syringe (9)
included in the scope of supply.

Turn the bleed screw (23) 180 degrees so
that the bleed hole (8) is in the position
shown (direction of the drive unit).

Pressurise the material.

Feed the material until it escapes from the
bleed hole (8) without bubbles.

Release (remove) the inlet pressure on
the material and wait until no more
material comes out of the bleed hole (8).

Close the bleed screw (23) again.

Remove any material which has escaped.

Pressurise the material.

Connect the drive unit to the power supply
and run slowly until the material escapes
from the outlet nozzle (attached Luer-Lock
needle) without bubbles.
Fig. 5
9
8
23
OPERATION