ViSAGE VIS127, Руководство пользователя, Страница: 11 / 28

Exits from the current menu or
function
current
Enables the currently displayed
menu or sets the currently
selected value in to the
function
menu list and increases the
Navigates upwards through the
numeric value when in a function
Navigates downwards through
the menu list and decreases the
numeric value when in a function
Control Options
Programming
DMX Operation
Stand-alone
Operation
Master/Slave
Operation
You can set the light start address in the 001~512 DMX range. This allows for
the control of up to 36 fixtures in the 14-channel ADVANCED DMX mode and up
to 46 fixtures in the 11-channel BASIC DMX mode. The Q-Spot 260 LED does not
support ID Addressing.
Carry out all the programming procedures indicated below from the control panel.
Refer to the Menu Map page to learn how the menu options relate to each other.
Use <ENTER> and <MENU> to change levels in the Menu M ap. This is equivalent
to move right and left respectively. Use <UP> and <DOWN> to move vertically
within theMenu Map options.
1) Select DMX operation
a) Go to MENU > INTRO > RUN
b) Select DMX512
2) Select a DMX mode
a) Go to MENU > INTRO > CHANNELS
b) Select BASIC or ADVANCED
3) Select the starting address
a) Go to MENU > INTRO > ADDRESS
b) Select a starting address, 001 ~ 498 (Advanced) or 001~501 (Basic)
1) Go to MENU > INTRO > RUN
2) Select a stand-alone operation mode (AUTO 1, AUTO 2, SOUND 1, SOUND 2,
CUSTOM or TEST)
1)Configure the Master fixture
a) Select a stand-alone mode, as indicated above
2)Configure the Slave fixtures
a) Go to MENU > INTRO > RUN
b) Select SLAVE
Of all the st and-alone operation modes i ndicated ab ove, o nly " CUSTOM" is
editable (see Edit Custom).
1) Go to MENU > INTRO > DISPLAY
2) Select a display mode (60 CLOSE or BRIGHT)
When in the "60 CLOSE" setting, the display backlight will turn off after 60 s.
When in the "BRIGHT" setting, the display backlight will stay on.
1)Go to MENU > INTRO > INFO
2)The display will show the installed software version.
--8--