Virutex CE24E, Инструкция по эксплуатации

Страница: 4 / 4

6
adjustment becomes necessary this is carried out
by screws F until the blades are parallel with the
base of the machine.
The blades supplied by VIRUTEX are reversible
(double-edge).
WARNING! Ensure that screws D are well tighte-
ned up before restarting work with the machine.
Only use VIRUTEX original spares for any spares
needed for the Blade-holder system.
7. CHANGING THE
TRANSMISSION BELT
Unscrew screws F (Fig. 3) and remove protection
E.
Replace the worn belt with a VIRUTEX original
spare, taking care to
fi t it correctly into the pulley
cogs, never forcing it. (Fig. 4).
8. MAINTENANCE OF THE
BRUSHES AND COLLECTOR
WARNING! Disconnect from the mains before
carrying out any maintenance operations.
The brushes must be replaced when they reach a
minimum length of 5 mm (Fig. 5).
Unscrew screws H and remove the ventilation
lid. Slip the brush-holder out of its guide. Replace
the brushes with original VIRUTEX ones, sliding
them gently into the brush-holder. Fit this back
into its guide and screw the lid back in place. It is
recommended that the appliance be left idling for
15 minutes to run the brushes in.
If the collector is burned or uneven it should be
repaired by a VIRUTEX service agent.
Always keep the lead and plug in good working
condition.
9. ASPIRATION NOZZLE ASSEMBLY
To fi t the nozzle, proceed as show in (Fig. 6). The
3.5 m standard aspiration coupling tube (Ref.
6446073) may be connected to the aspiration
no zzle and that tube can be connected to the
AS182K, AS282K vacuum unit.
NOTE! Do not use the brush with the aspiration
nozzle
fi tted without fi rst connecting up the machine
to a vacuum unit, since otherwise chips may block
the nozzle.
10. LATERAL FENCE
For planing operations following the edge of the
wood. Adjusted by means of knob G (see Fig. 1).
11. OPTIONAL ACCESSORIES
AND TOOLS
11.1 TOOLS
3540118 - Set of reversible straight MD blades
CE24E/CE35E (Included with equipment)
3531019 - Set of reversible straight AR blades
CE24E/CE35E
3599101 - Set of standard blades
11.2 ADJUSTABLE LATERAL
FENCE 2200018
Features: for different degrees of chamfer.
Assembly: screw the two screws J, incorporated in
the try square, into the holes which are on the same
side of the plane as the belt guard (Fig. 3).
Adjustment: loosen knob K and, using knob M,
shift the try square sideways.
Adjust the degrees of chamfer by means of wing
nuts L (Fig. 3)
12. NOISE AND VIBRATION LEVEL
The noise and vibration levels of this electrical
device have been measured according to the
European standard EN50144.
The noise level in the workplace can exceed
85dB(A), in which case it is necessary for the
user to take noise protection measures.
13. WARRANTY
All VIRUTEX power tools are guaranteed for 12
months from the date of purchase, excluding any
damage which is a result of incorrect use or of
natural wear and tear on the machine. All repairs
should be carried out by the of
fi cial VIRUTEX
technical assistance service.