EN
VirtuFit Elite TR-500i Treadmill
20
TROUBLE SHOOTING
There is no signal when power on
• First check whether the over load protector is open or not, if opened, please close it.
• Make sure the wire of the switch, over load protector and driver are connected well.
• Make sure the wire between the monitor and driver is connected well.
The display shows E01 after switch on
• There something wrong with the signal cable. Please check each cable between display and the
driver is ok or not.
• There are something wrong with the display component part, please replace the display.
• Replace the transformer.
The display shows E02 after switch on
• Check the motor cable is ok or not, if not please reconnect the motor cable. If it does not work, please
replace the motor.
• Check the controller whether there is any special smell. If so please replace the controller.
• Check whether the input voltage is correct or not. Please use the right input voltage.
The display shows E03 after switch on-----no sensor signal
• If the motor start working for about 5-8 seconds and then the monitor displays E03. E03 stands for
there is no speed signal. Please check whether the speed sensor is connected well or not. In addition
please check whether the sensor is broken or not.
• The sensor wire on the PCB board is broken, please replace the PCB board.
The display shows E04 after switch on
• Please check whether the signal wire of the incline motor is ok or not, please pull of the connector
and insert it again.
• Please check the connection of the AC wire of the incline motor is correct or not. Please check
according to drawing.
• Please check whether the wire of the incline motor is broken or not, if it is broken please replace the
wire or the incline motor.
• Replace the PCB board.
• After checking all of the PCB, please press the LEARNING key to learn it again.
The display shows E05 after switch on-----overload protection
• The load is too big, please reset.
• Maybe some part is jammed which make the motor too heavy, so the machine cannot work. Please
adjust the running belt or lubricate some oil.
SIMPLE MALFUNCTION AND SOLUTION - LED SCREEN
