Virtue Sensation Owner’s Manual
http://www.virtueaudio.com
Page 7 of 7
a. After about 3 seconds, Protection LED will go from yellow, to red, to off and Standby
LED will stay on
3. Turn on the front power switch on Sensation or by remote
a. Red Standby will go off, Blue “On” LED will come on
Turning Off the Amplifier
In most cases you only need to turn off the front power button in daily use and enjoyment to keep your
Sensation in standby mode. This way it will be ready to play when you are ready to listen. However, if
you need to fully power down Sensation and the power supply in order to change connections or make
any internal adjustments or tube swaps (if you’re one of those lucky dogs with the Dodd Buffer) then
you MUST follow the full power down procedure below.
You should fully power down your Sensation amplifier and the power supply to:
•
Take off the top and look inside Sensation to see the Special Sauce
•
Change tops, sides or any other exterior structural changes
•
Make internal adjustments to the jumpers, caps, tube and other doohickies inside
•
Change speakers or inputs
•
Switch the Dodd Tube Buffer
on
or
off
•
Switch between power supplies and/or batteries
•
Protect Sensation from power outage during storms
•
Just don’t want the power supply or battery on
Full Power Down Sequence
1. Turn off front power button (or turn off by remote)
2. Turn off rear power rocker switch
3. Unplug the power supply from the back of Sensation
Please do NOT rapidly turn on and off the unit. If Sensation goes into protection mode, turn off the
master power switch and wait 90 seconds for Sensation to reset.
