Virtualfly TQ6+ Скачать руководство пользователя страница 5

Страница: 5 / 5

TQ6+ | User's manual

Let you know that PROPELLER and MIXTURE axes must be configura-
ted on X-Plane menus and THROTTLE axes must be configurated on
VF-Test&Calibrate-X.

PROPELLER AND MIXTURE
1. Open

X-Plane

and go to Configuration\Joystick tab.

2. Select TQ6+ and calibrate the axes if required, only for the Propeller

and Mixture axes (including FTH and CUT OFF zones).

3. Assign the according action for the Propeller and Mix ture axes to

Prop1 – Prop2 – Mixture1 – Mixture2 and check "Reverse Axis".

Make sure that the TQ6+ Throttle axes are set to "none".

THROTTLE
4. Open

VF-Test&Calibrate-X

software, go to TQ6 tab and select the

device from the devices list at right side.

5. Calibrate IDLE point of the THROTTLE and save changes.
6. VF-Test&Calibrate-X has to be running when using TQ6+ because

this software reads the data from the device and send it to X-Plane so

each time you start X-Plane, you have to run VF-Test&Calibrate-X
as well

. You can use Windows Scheduler to start VF-Test&Calibrate-

X automatically.

TQ6+ Configuration options on

X-Plane

You have to use the Soft VF-Test&Calibrate-X

downloadable from our web-site:

www.virtual-fly.com/en/downloads

Full functionality:

Throttle-Rev, Propeller-Fth, Mixture-CutOFF.

Содержание TQ6+

Страница 1: ...TQ6 User s manual 1 1 PACKAGE LIST A TQ6 Throttle quadrant B Clamp for TQ6 C Screws for clamp D Allen key TQ6 Throttle Quadrant USER S MANUAL Rev 1 0 September 2018 C D 1x 1x 1x 4x A B ...

Страница 2: ... get the best position for you If you choose the bottom position you must unscrew the two front rubber feet before you screw the clamp Connect the USB cable to the computer where the flight simulator software is running It is not necessary the calibration on windows because the device is calibrated from factory 1 2 ...