3: Installing a GW7000 Series router in the UK before it is automatically configured
3.3
Installing a GW7000 Series router with an E1/T1 connection in the
UK
Figure 4: The cables you need for an E1/T1 and power connection
1.
For a standard connection, connect one end of the E1/T1 cable to the E1/T1 port on the
back of the router and the other end of the cable to an E1/T1 switch.
2.
For a back-to-back connection, connect one end of an E1/T1 cross over cable to the
E1/T1 port on the back of the router. Connect the other end of the cable into the E1/T1
port of another device.
3.
Connect the power supply connector to the power port.
The router initialises. The CONFIG LED flashes and all the LEDs temporarily light in
sequence. Then the router activates.
The activation process can take between 5 and 10 minutes. The CONFIG light flashes
throughout activation. When activation finishes, your router enters operational mode.
If the LEDs on the router are not correctly lit, check that:
the cables are attached correctly, and
your service has been enabled by your provider.
3.4
Installing a GW7000 3G connection in the UK
WARNING
The SIM card MUST be inserted into the router before the unit is powered on.
Do not insert or remove the SIM card after the unit has been powered on.
1.
Ensure the unit is powered off.
2.
Hold the SIM card with the chip side facing down and the cut corner top left.
3.
Gently push the SIM card into SIM slot 1 until it clicks in.
To remove the SIM card, gently push the SIM card. The card will click out.
Installing a GW7000 Series Router
© Virtual Access Ltd.
Issue 1.3
Page 9 of 19
