VIQUA Water Filters Installation and Replacement
Section 1
Safety Information
1.1 Safety Precautions
Section 2
Installation
C A U T I O N
If water pipes are used to ground electrical system, appliances, or phone, install a jumper wire.
N O T I C E
Read and understand this Instruction Sheet before operating and performing any maintenance on this equipment.
Warning:
This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
W A R N I N G
•
DO NOT install on line pressures above 125 psi (6.9 bar).
•
DO NOT overtighten pipe fittings.
•
DO NOT use wicking or sealer, Teflon
™
tape is recommended.
•
DO NOT use torch near plastic housing. All sweated joints should be made prior to assembling piping to the filter head.
•
Replace O-ring seal, if there is visible damage.
•
Maximum temperature allowed is 38 °C (100 °F). Special hot water filters are available for higher temperatures.
•
Protect the filters from freezing temperatures.
•
DO NOT install in direct sunlight.
•
Allow minimum of 2” clear space under filter to facilitate cartridge change.
•
DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Instruction Sheet
520071_RevG
