CD-ROM Box Enclosure Installation Guide
3
2-1.2 Assemble CD-ROM Box with CD-ROM Drive
1. Mount the two drive rails, one on each side of the CD-ROM drive. Position each
rail such that it extends beyond the back of the drive. Then, align the mounting
holes of each rail with the holes on the CD-ROM drive and secure with four
supplied screws. See figure below for location of mounting holes to be used.
2. Attach the two connectors from the end-panel assembly to the appropriate
connectors on the CD-ROM drive.
a. Attach the IDE 40-pin data cable from the end-panel to the 40-pin connector
on the back of the CD-ROM drive. To ensure pin-1 to pin-1 connection,
orient the cable so the colored stripe edge is closest to the power connector.
b. Attach the 4-pin power cable from the end-panel to the 4-pin connector on the
back of the CD-ROM drive. The connector is ‘D’ shaped to ensure proper
connection
Power/Data Connectors and Drive Rail Connections
4-pin Power
Connector
40-pin IDE
Data Connector
Drive Rails (x2)
Mounting
Screws
(x4)
CD-ROM
Drive
Pin-1 Colored
Stripe
End-Panel
Assembly
NOTE: Drive rails should
extend beyond back of
CD-ROM drive
Completed Setup Connections
