SAFETY PRECAUTIONS
GROUNDING INSTRUCTIONS
General –This floor – finishing machine shall be
grounded while in use to protect the operator
from electric shock. The machine is provided
with a three –conductor cord and a three contact
grounding type attachment plug to fit the proper
grounding type receptacle. The green [or green
and yellow] conductor in the cord is the
grounding wire. Never connect this wire to other
than the grounding pin of the attachment plug.
This machine is for use on a nominal 120-Volt
circuit and has a grounding plug that resembles
the plug illustrated in figure below. Make sure
that the machine is connected to an outlet
having the same configuration as the plug. No
adapter should be used with this machine.
This machine is intended for Commercial use. It
is constructed for use in an indoor environment
and is not intended for any other use. Use only
recommended accessories.
All
operators
shall
read,
understand
and
exercise the following safety precautions:
1] Do not operate machine:
-
Unless trained and authorized.
-
Unless you have read and understand
operators manual.
-
In flammable or explosive areas.
-
With a damaged cord or plug.
-
If not in proper operating condition.
-
In outdoor areas.
-
In standing water.
-
With the use of extension cords.
2] Before operating machine:
-
Make sure all safety devices are in place
and operate properly.
3] When using machine:
-
Do not run machine over cord.
-
Do not pull machine by cord or plug.
-
Do not pull cord around sharp edges of
corners.
-
Do not unplug by pulling on the cord.
-
Do not stretch cord.
-
Do not handle plug with wet hands.
-
Keep cord away from heated surfaces.
-
Report
machine
damage
of
faulty
operation immediately.
4] Before leaving or servicing machine:
-
Turn off machine.
-
Unplug cord from outlet.
5] When servicing machine:
-
Unplug cord from outlet.
-
Use manufacturer supplied or approved
replacements parts.
-
3
