Viper d1200.1, Руководство пользователя

Страница: 8 / 24

8
© 2002 Directed Electronics, Inc
1. RRCCAA IInnppuutt JJaacckkss - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
2. RRCCAA SSyynncc OOuutt// SSllaavvee IInn JJaacckk
Sync Out - This RCA jack sends a
Synced or in-phase gain matched
output signal to a slave amplifier
when connected in the Parallel
Synced Gain combination. It is a
Synced output when the
slave/master switch is in the
MASTER position only.
Slave In - This RCA jack accepts
input from a master amplifier. It is
for use in the Parallel Synced Gain
and External Synced Bridged combi-
nations. It is a slave input when the
slave/master control switch is in
the SLAVE position only.
3. RRCCAA BBrriiddggee OOuuttppuutt JJaacckk - This output
sends an out-of-phase signal to a
slave amplifier when connected in
the External Synced Bridged combi-
nation. (Refer to the
Combined
Amplifiers section of this guide.)
4. SSllaavvee//M Maasstteerr SSw wiittcchh - Controls
whether the amplifier is a slave or
master when connected in
combined amplifier configurations.
(Refer to the
Combined Amplifiers
section of this guide.)
5. RReem moottee SSuubb LLeevveell CCoonnttrrooll - Controls
the subwoofer amplifier gain
controls from a remote location for
ease of adjustment during listening.
W Waarrnniinngg:: DO NOT connect a level control knob from other
manufacturers to the Remote Sub Level Control of
any Viper amplifier. Even though the connectors fit
properly, the control knob and connector pin posi-
tions may be different and the amplifier will be
damaged.
FRONT PANEL CONNECTIONS
FIGURE 1—AMPLIFIER CONNECTIONS d600.1/d1200.1 FRONT
3 1 4 5
2