Viper 5606V, Руководство пользователя

Страница: 31 / 42

27
© 2016 Directed. All rights reserved.
Valet Mode
Valet Mode can be entered and exited by performing the Remote
Valet command or manually using the vehicle key and the control
button. When entered, the alarm functions are defeated while the
convenience features still operate normally.
Use the following steps to manually enter and exit Valet Mode:
1.
Turn the ignition switch on, and then off.
2. Immediately press and release the Control Center button once.
3. The Control Center LED turns on when entering, and off when
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Armed the
flashing is reduced after 24 hours. When Valet Mode is ON, the LED
turns off after one hour, and resets each time the ignition is turned off.
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system re-
tains and returns to the last state it was in at the time of disconnection,
once power is reconnected.
Car Select
Car 2 remote control option must first be turned ON (see under “Re-
mote Control Configuration” on page 14 to turn on).
Press
and
hold
the
AUX
button for three seconds. The LED flashes once or twice to
indicate the selected Car is 1 or 2, release the button for Car Select,
or continue to
hold
for programming.
Release
the
AUX
button, then
press
and
release
while the LED flash-
es continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.