Viper 550HF, Руководство пользователя

Страница: 8 / 20

8
© 1997 Directed Electronics, Inc.
To enter or exit Valet
®
Mode with the Valet
®
switch:
Turn ignition to "run" position, then turn to "off" posi-
tion. Press and release the Valet
®
switch within 10
seconds. The Status LED will light steady if you have
entered Valet
®
Mode, and it will go out if you exited
Valet
®
Mode.
Using Remote Valet ® as you enter or exit the vehicle:
Open any door. Press Button I (or the arm/disarm Button) Press button II (or
the channel 2 button). Press Button I again. The Status LED will light steady
if you have entered Valet
®
Mode, and it will go out if you exited Valet
®
Mode.
Remote Starting the Vehicle
Pressing Buttons I and II at the same time
will begin the remote start sequence. The
parking lights will flash to confirm that the
motor is going to start. It is important to
release the transmitter buttons as soon as
the parking lights flash. If the buttons are pressed longer than
two seconds, the system will stop the remote start sequence. About three
seconds after the parking lights flash, the system will engage the starter until
the vehicle is successfully running. If the motor is not running after six sec-
onds, the system will stop cranking the starter. After three seconds, the sys-
tem will try to start the motor again. If your motor is not running after three
attempts, the system will stop the remote start sequence. It is not necessary
to disarm your system before remote starting the vehicle. The shock sensor
will be bypassed whenever the system is running the motor.
IMPORTANT! It is unsafe to run a vehicle’s motor in a garage or other closed off area. Breathing
the exhaust from the vehicle is hazardous to your health. Never activate the remote start system
in an enclosed space.
1
2