16
© 1998 Directed Electronics, Inc. Vista, CA
N438 7/98
TRANSMITTER/RECEIVER LEARN ROUTINE
™
In order to enter Learn Routine
™
, the jumper under the sliding door must be placed into learn position (see page
9). The Valet
®
/Program button, plugged into the blue port, is used for programming. There is a basic sequence to
remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1. Door
Open a door. Either the H1/5 green or the H1/7 violet door
trigger wire must be connected for the control unit to “see” an
open door.
2. Key
Turn the ignition on to the run position. The H1/9 yellow
switched ignition input must be connected.
3. Choose
Within 15 seconds, press and release the momentary button to
select the channel you wish to program:
Press and Release
To Program
One time
Arm/disarm/panic
Two times
Channel two output
(Silent Mode™/Remote Valet® )
Three times
Channel three output
Once you have selected the step, press the button once more and hold it. The unit will chirp one, two or three times
depending on the channel selected. Do not release the momentary button.
4. Transmit
While holding the momentary button, press the button on the
transmitter that you would like to control the selected receiver
channel. One chirp will confirm that the code has been learned.
5. Release
Once the code is learned, the Valet
®
button can be released.
You can step from one step to another by releasing the Valet
®
/Program button and tapping it to advance steps and
then holding it. For instance: You have programmed channel one and you want to program channel two. Release
the Valet
®
/Program button. Press it one time and release it to advance from step one to step two. Now, press and
hold the button down and the unit will chirp twice. As before, do not release it.
If you want to program channel three after programming channel one, release the momentary button press it twice
and release it to advance to step three. Then press it once more and hold it. The siren will chirp three times to con-
firm it is ready to receive the code from the transmitter.
Learn Routine
™
will be exited if:
•
Ignition is turned off.
•
Door is closed.
•
Program button is pressed too many times.
•
More than 15 seconds elapses between steps.
One long chirp indicates that Learn Routine
™
has been exited.
